P26D2
Engine Coolant Pump Control Module Over Temperature
The electronics of a smart coolant pump also measure their own temperature. P26D2 is set when this value climbs too high: in Ford's hybrid OBD summaries the pump module reports the temperature over LIN and the PCM stores P26D2 once it passes 130 °C for five seconds. The electronics are cooled by the coolant flowing through the pump, so overheating usually means poor flow – a low coolant level, trapped air, a partly blocked impeller drawing excessive current, or very hot under-bonnet conditions. Ford also uses the over-temperature state as a reason to suspend its pump communication check. The code differs from P0217, which concerns the engine coolant itself. The pump may reduce power or shut down to protect itself, so engine temperature can rise quickly.
Possible causes
- Low coolant level or air around the pump reducing cooling of its electronics high
- Stiff impeller or bearing making the motor draw high current medium
- Internal fault in the pump electronics or temperature sensor low
Symptoms
- Check engine lamp on
- Engine temperature rising or temperature warning
- Reduced heater output
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P26D2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.