P26CF
Engine Coolant Pump Control Module System Voltage
Smart coolant pumps carry their own electronics, which measure the supply voltage they receive. P26CF is the general code for that voltage when it is implausible but cannot be assigned to too low or too high. No manufacturer documents P26CF itself in public. Ford's hybrid OBD summaries show the principle with the sister codes P26D0 and P26D1: the pump module sends its electronics voltage over LIN, and the PCM compares it with its own battery reading. CARB requires electronic components that affect emissions to be checked for plausibility. A general system voltage fault usually points to a shared cause – loose grounds, a weak battery, charging problems or intermittent contact – rather than to the pump. The pump may reduce its output or stop.
Possible causes
- Loose, corroded or intermittent pump supply or ground connection high
- Weak battery or charging system fault medium
- Faulty voltage measurement in the pump electronics low
Symptoms
- Check engine lamp on
- Other voltage-related codes stored at the same time
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P26CF
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.