OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P26CD

Engine Coolant Pump Control Circuit High

P26CD is set when the control circuit of the engine coolant pump shows a higher voltage than the commanded state allows, for example while the driver is switched off. No manufacturer documents this code in public. CARB's OBD rule asks for output components to be monitored for circuit faults, and the same pump circuit is known from its low-side partner P26CC, which Honda documents on its hybrids in bulletin 25-020. Typical high faults are a control wire touching battery voltage, a relay whose contacts weld shut so the pump keeps running, or an open ground on the pump side. Depending on design the pump then runs permanently or cannot be regulated; the engine module usually stores the code at once and lights the MIL, while warm-up may take longer.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / CD

Possible causes

  • Pump control wire shorted to battery voltage high
  • Pump relay contacts stuck closed medium
  • Open ground at the pump pulling the circuit high low

Symptoms

  • Check engine lamp on
  • Pump running after the engine is switched off
  • Longer warm-up phase

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P26CD

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication