OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P26CA

Engine Coolant Pump Control Circuit/Open

Many engines replace the belt-driven water pump with an electric pump that has its own control electronics. P26CA flags a fault in the control connection to that pump. In the Ford 2.0 L hybrid system the pump is commanded over LIN and also has a backup run line wired to ignition; the PCM compares the state of this line reported by the pump with the real ignition state and sets P26CA after five seconds of mismatch. Toyota applies it to A25A engines (Camry, RAV4, Highlander, Sienna and Venza, 2020–2024) use the code with suffixes for a grounded or broken circuit and for a missing signal, in some cases with coolant leaking from the pump into its connector. Ford service messages 46857 and 47790 trace it to water in harness connectors. The pump may run on a fallback speed or stop.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / CA

Possible causes

  • Water or corrosion in the pump connector or harness connectors high
  • Coolant leaking from the pump body into its electronics medium
  • Broken control or backup run wire between module and pump medium

Symptoms

  • Check engine lamp on
  • Rising coolant temperature or temperature warning
  • Coolant traces at the electric pump

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P26CA

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication