P26C8
Chassis Control Module 1 Requested MIL Illumination
P26C8 is not a fault of the engine module itself. It is stored when a unit outside the powertrain, which the manufacturer designates chassis control module 1, has logged an emission-related code of its own and asks the engine module over the network to light the check engine lamp. GM lists it in the engine tables 18OBDG04 and in the hybrid tables 18OBDG01: the request message is watched continuously from three seconds after power-up, and the code is Type A but carries no lamp request of its own. GM preliminary information PIT6010 (Buick LaCrosse, Cadillac XT5 2017–2019) mentions P26C8 together with U135A after a transmission range control module was replaced and its software did not match. The real cause is found in the memory of chassis module 1, which has to be read first.
Possible causes
- Emission-related fault stored in chassis control module 1 high
- Replaced module with mismatched or missing software configuration medium
- Low supply voltage or network disturbance during start-up low
Symptoms
- Check engine lamp on
- Service transmission or chassis warning message
- Additional codes stored in the chassis module
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P26C8
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.