OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P26C0

Engine Coolant Bypass Valve D Stuck/Open

GM uses P26C0 for the block rotary valve, which controls coolant flow through the engine block between two mechanical end stops; its tables label it as the engine block coolant valve stuck open. The ECM counts a failure when requested and measured position differ by at least 10° while the raw feedback sits at 50° or more, i.e. on the open side. The 2019 L3B table grades it Type A, one trip; the 2025 table 25OBDG03B lowers the gap to 5° and grades it Type B. The check is suspended during the valve's calibration run and needs at least 11 V. GM bulletin 21-NA-149 lists P26C0 among codes caused by a chafed engine harness on 2019–2021 trucks. An open block valve lets the block stay cooler than intended, slowing warm-up.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / C0

Possible causes

  • Block valve jammed on the open side high
  • Chafed engine harness disturbing drive or feedback (GM 21-NA-149) medium
  • Position feedback reporting a wrong angle low

Symptoms

  • Check engine light
  • Longer warm-up, especially in cold weather
  • Higher fuel consumption on short trips

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P26C0

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication