OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P26BE

Engine Coolant Bypass Valve D Control Circuit Low

P26BE flags a drive circuit of valve D that reads too low, normally because the wiring or the valve itself is grounded. No manufacturer documents P26BE publicly. Ford, whose valve D is the cabin heating valve, reports only the general circuit code P26BD and, from 2024, the short-to-battery code P26BF. The closest documented logic belongs to valve C: GM's 2025 diesel table looks for grounded lines on that valve's H-bridge in each motor direction and grades it Type B. CARB requires output circuits to be monitored for circuit faults. A grounded line may keep a low-side driven valve energised or make the driver cut out. On a heater valve the result is mostly wrong cabin temperature, though a valve in the engine loop can also upset warm-up.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / BE

Possible causes

  • Drive wire shorted to ground high
  • Internal short in valve D medium
  • Moisture or corrosion in the connector low

Symptoms

  • Check engine light
  • Cabin heat stuck at full or at minimum
  • Valve D does not react to commands

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P26BE

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication