OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P26BB

Engine Coolant Bypass Valve C Range/Performance

P26BB is GM's main functional code for its rotary coolant flow control valve. The ECM compares commanded and measured angle; a gap above 12° after the target has settled, or movement slower than calibrated, counts as a fault. In the 2019 L3B table this is Type A (4 of 5 s), in the 2025 diesel table Type B (8 of 10 s). Several GM bulletins concern it: 21-NA-256 (2019–2022 engines LSY, L3B, L3T) blames a break-in phase of the valve under about 2,000 miles and calls for a new valve only on repeat; 20-NA-100 (2.7L L3B pickups 2019–2020) and 22-NA-082 (3.0L diesel 2020–2022) prescribe new ECM software; PIE0697 gathered field data on the diesel with P2B60. A sluggish valve can let the engine run too warm or too cool.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / BB

Possible causes

  • New valve still in its break-in phase (GM, low mileage) high
  • ECM calibration needing an update per GM bulletin medium
  • Valve or actuator sticking or worn medium
  • Inaccurate valve position feedback low

Symptoms

  • Check engine light
  • Coolant temperature higher or lower than normal
  • Code may disappear after further driving on a new valve

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P26BB

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication