OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P26B5

Fuel Shutoff Valve B Control Circuit Performance/Stuck Off

With P26B5 shut-off valve B fails to open or pass fuel when commanded. Roush CleanTech documents the code for its Gen 4 propane system on 2016–2018 Ford trucks, where valve B is the supply solenoid in the module that regulates rail pressure (its circuit code there is P2665). Once a start is initiated, the system module checks how far rail pressure climbs; too small an increase stores P26B5. Listed causes include a tripped excess flow valve, a manual valve not fully open, a tank or supply solenoid that does not open, weak pumps, a blocked filter or kinked lines. The engine then cranks without starting or runs poorly, as the system cycles pumps and solenoids to build pressure. MIL status varies by model. P26B6 is the stuck-on case.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / B5

Possible causes

  • Supply or tank solenoid not opening high
  • Manual valve partly closed or excess flow valve tripped medium
  • Weak fuel pumps, clogged filter or kinked lines medium
  • Blown fuse in the valve circuit low

Symptoms

  • Engine cranks but does not start, or runs poorly
  • Long start sequence with pumps cycling repeatedly
  • Check engine light on some models

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P26B5

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication