P26AA
Engine Coolant Bypass Valve A Position Sensor Maximum Stop Performance
P26AA is the upper-limit partner of P26A9: the controller cannot confirm or learn the maximum end stop of valve A, or the reported value at full travel lies outside the expected window. No manufacturer publishes criteria for this code. GM's Volt logic for P26A9 shows how such checks work: the valve is driven to an end, given a fixed time to arrive and relearned several times before a fault is stored. Subaru's bulletin 09-80-21 names the P26A family in general for sensor corrosion on its thermo control valve. CARB expects the OBD system to notice when such an output ignores its commands, wherever a test of its response is feasible. Likely causes are mechanical binding near full open, a damaged stop, or a sensor that saturates early.
Possible causes
- Valve binding before reaching its maximum position high
- Worn or broken mechanical end stop or gear medium
- Position sensor out of calibration near its upper end low
Symptoms
- Check engine light
- Reduced cooling under high load
- Heater or engine temperature not as expected
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P26AA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.