OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P26A9

Engine Coolant Bypass Valve A Position Sensor Stop/Minimum Stop Performance

The title refers to the learned end stop of valve A. GM's use of P26A9 shifted over time. On the 2011 Volt it covered feedback sitting in a forbidden zone (5–30 % or 70–95 %), sudden jumps above 6 % and slow drift above 3 %, all Type B. In the 2016 Volt table the VICM uses it when the valve misses its commanded position within 15 s, retries the end-position learn up to three times with 10 s each, and still fails; coolant must be above 58 °C, and GM notes that an open drive circuit also spoils the learn. The 2016 ELR section treats a failed end-position learn above 50 °C the same way. Subaru's 09-80-21 includes the P26A series. A sticking valve, deposits in the housing or a valve fitted without a relearn are typical causes.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / A9

Possible causes

  • Valve rotor sticking from deposits or contaminated coolant high
  • End position not relearned after valve or module replacement medium
  • Open motor drive circuit preventing the learn routine medium
  • Drifting position sensor misreporting the stop low

Symptoms

  • Check engine light after two drives
  • Engine overheats or stays too cool depending on stuck position
  • Weak or uneven cabin heat

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P26A9

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication