OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P26A7

Engine Coolant Bypass Valve A Position Sensor Circuit High

The counterpart to P26A6: the feedback from valve A reads too high. GM's 2016 Volt table counts both a signal above its window and a broken signal circuit here, because an interrupted wire lets the input float toward the reference. The limit is 95 % of the reference (4.75 V), checked as 40 failures in 50 samples at 100 ms, Type B. The 2011 Volt table uses the same 95 % rule but prints the voltage as 4.25 V. Subaru's correction bulletin 09-132-25 also covers P26A7 for its boxer engines and again drops the first step of the published test. Subaru's earlier bulletin 09-80-21 replaced the thermo control valve with a better sealed sensor section. Check for a broken signal or ground wire and for a short to the 5 V supply before condemning the valve.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / A7

Possible causes

  • Open feedback or sensor ground wire high
  • Feedback wire shorted to 5 V reference or battery voltage medium
  • Defective sensor in the valve housing medium

Symptoms

  • Check engine light
  • Scan tool shows valve position at maximum
  • Engine slow to reach operating temperature

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P26A7

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication