P26A5
Engine Coolant Bypass Valve A Position Sensor Circuit Range/Performance
Here the feedback signal is electrically present but sits where a healthy valve should never be. In GM's 2016 Volt table the VICM treats readings between 5 and 30 % or between 70 and 95 % of the reference as invalid; 80 failures in 100 samples at 100 ms give a Type B fault, provided the drive codes P2682/P2683/P26AD/P26AE and P26A6/P26A7 are clear. The same GM document lists a faster 3-of-5 variant for the ELR. On the first-generation Volt (2011) this zone check was still part of P26A9. Subaru's bulletin 09-80-21 blames sensor corrosion for P26A-series codes and fits a redesigned valve. A worn sensor track, a damaged gear between motor and sensor or a mis-seated connector are the usual suspects.
Possible causes
- Worn or corroded position sensor track inside the valve high
- Damaged gear or coupling between valve motor and sensor medium
- High contact resistance at the valve connector medium
Symptoms
- Check engine light after two drives
- Engine runs too cool or warms up slowly
- Fluctuating heater output
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P26A5
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.