OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P26A4

Engine Coolant Bypass Valve A Position Sensor Circuit

Many electric coolant valves carry a potentiometer or Hall element that reports the actual valve angle back to the controller. P26A4 is the general circuit code for that feedback on valve A: the signal is missing or cannot be assigned to a more specific low, high or erratic fault. No manufacturer documents P26A4 itself in public. GM's Volt tables cover the same sensor only through P26A6/P26A7, and Subaru bulletin 09-80-21 (Forester, Outback, Legacy, Crosstrek 2019–2021) mentions P26A-series codes in general when water reaches the sensor portion of the thermo control valve. CARB requires input signals to be checked for continuity. Without valid feedback the controller loses track of the valve, so warm-up and cooling may run on a fallback setting.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / A4

Possible causes

  • Moisture or corrosion inside the valve's position sensor section high
  • Loose, corroded or damaged connector or feedback wiring medium
  • Missing 5 V reference or ground for the position sensor low

Symptoms

  • Check engine light
  • Slow warm-up or weak cabin heat
  • Possible additional valve or coolant temperature codes

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P26A4

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication