OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2699

Exhaust Aftertreatment Fuel Injector A Circuit Low

P2699 flags the drive circuit of the exhaust fuel doser as too low, usually a grounded control wire or a shorted valve coil. The difference to P2697 matters in practice: an open circuit simply stops dosing, while a grounded line can switch the valve on without command if the short sits behind the driver, so raw fuel may reach a cold catalyst. Volvo and Mack list P2699 with failure type 00 among the electrical faults of their aftertreatment hydrocarbon injector system and send the technician to the dosing module plug and harness, in the same guide that covers the open and high cases. No other maker documents the code publicly. Expect a lit MIL, cancelled regenerations and, if dosing stays blocked, a rising filter load with eventual power reduction.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 99

Possible causes

  • Doser control wire grounded against the frame or exhaust bracket high
  • Shorted coil of the dosing valve medium
  • Fuel or water inside the module connector low

Symptoms

  • MIL on and regeneration inhibited
  • Possible white smoke if the valve opens uncommanded
  • Derate after prolonged soot build-up

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2699

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication