P268E
Cylinder 3 Injector Data Incompatible
For cylinder 3 the controller compares the injector's correction value with what its software accepts. Ford's 2023 diesel OBD summary explains the idea well: each injector's code, kept in EEPROM, describes how far that unit departs from an idealised mean part, and a DTC is logged if the value is absent, out of range or its checksum is wrong. The monitor runs continuously and needs about half a second. GM's 2019 V8 diesel table 19OBDG04A rates P268E Type A, so the lamp lights in the first trip. Because only the data is checked, the injector itself may be perfect; the usual fix is to read the code off the injector head and program it into the controller.
Possible causes
- Cylinder 3 injector replaced, code not programmed high
- Code from an injector variant the software does not accept medium
- Stored injector data corrupted in the controller low
Symptoms
- Check engine light on
- Usually no noticeable driveability change
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P268E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.