OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P268C

Cylinder 1 Injector Data Incompatible

Every modern diesel injector carries a correction code from the factory flow test, and the controller must hold the code of the injector in cylinder 1. P268C sets when that code is missing, outside its range or fails the checksum. GM's 2014 four-cylinder diesel table (14OBDG04) checks the injector quantity adjustment (IQA) checksum once per drive cycle before driving, Type B. Later GM V8, six- and four-cylinder diesel tables rate it Type A, set if the code at DID $60 was never written. Ford's 2023 diesel summary (6.7 L and 3.0 L) runs the check continuously within about 0.5 s. Cylinder 1 exists on every engine, so this is the most widely used code of the series.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 8C

Possible causes

  • Correction code of a new cylinder 1 injector not entered high
  • Code entered with a typing error, so the checksum fails medium
  • Controller replaced without transferring injector codes medium

Symptoms

  • Check engine light on
  • Uneven running or knock from cylinder 1

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P268C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication