OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P268A

Fuel Injector Calibration Not Learned/Programmed

P268A covers injector correction that relies on a learn routine rather than a printed code. GM's diesel tables 17OBDG04 to 19OBDG04A set it, Type A in one trip, when the small quantity learning (SQL) routine was not completed and stored before the vehicle left the assembly line. VW's 2014 Touareg 3.0 TDI (CNRB) lists it for a rail pressure deviation above 1,500–2,000 kPa lasting over 40 s. Audi's 2026 service note 2082225/1 reports it with the MIL on 2025–2026 A5 and Q5 2.0 TFSI petrol engines as a software issue. Deutz MD1 links it to a calibration fault of injector 1. Per-injector code faults use P268C–P2696. Symptoms range from none to rough idle and knock.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 8A

Possible causes

  • Injector quantity learn not completed after injector or controller replacement high
  • Engine control software fault (e.g. Audi 2.0 TFSI 2025–2026) medium
  • Rail pressure deviation preventing correct learning low
  • Injector worn beyond the correction range low

Symptoms

  • Check engine light on
  • Rough idle or louder combustion noise
  • Often no noticeable change in driving

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P268A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication