OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2689

Fuel Supply Heater Control Circuit High

P2689 is logged when the fuel heater control line stays high even though the controller has commanded it on, so the relay coil is fed from battery positive and cannot be pulled in; the heater never works. GM's diesel ECM checks the low-side driver in its on state and treats 0.5 ohm or less to power as a short; the 2020 table uses 10 of 20 samples at 100 ms and Type C without lamp or message, while the 2014 table sets it as Type B. Ford's 2015 and 2016 diesel summaries give the code two jobs on the 3.2 L Transit: a vaporizer glow plug line held in the 10.9–12.32 V band for 5 s, and a relay status that contradicts the request for about 60 s, marked as provisional. In 2017 Ford split those into P269E and P26A0. Cold-weather starting is the main thing at risk.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 89

Possible causes

  • Control wire shorted to a battery-fed wire high
  • Heater relay sticking so feedback no longer matches the command medium
  • Low-side driver in the engine controller defective low

Symptoms

  • No fuel heating, gelling risk below freezing
  • Hard cold starts and rough idle until warm
  • Warning lamp only on some model years

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2689

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication