OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2685

Actuator Supply Voltage C Circuit Low

P2685 means the third actuator supply rail sags while it is switched on, almost always because the line or one of the loads it feeds has a path to ground. Unlike the open and switch faults of this rail, GM's 2023 and 2024 TCM tables check this one continuously during operation: if the voltage at high-side output 7 falls below a share of the supply, or the averaged output current runs too high, a timer counts up and the fault is confirmed after 60 ms. Battery voltage must lie between 8.75 and 18 V, the engine must not be cranking, and the test is suspended when P0882 or P0883 is present; GM rates it Type A. Ford's 2024 summary lists P2685 as the shorted-load fault of high side driver 7 in the TR9070 dual-clutch unit. The protected output switches off and the transmission falls back to a failsafe mode.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 85

Possible causes

  • Supply wire chafed through and touching ground high
  • Shorted solenoid coil on this rail drawing excess current medium
  • Weak battery or charging fault pulling the whole supply down low

Symptoms

  • MIL on during the same trip
  • Failsafe gear, no normal shifting
  • Blown fuse possible on the transmission supply

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2685

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication