OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2684

Actuator Supply Voltage C Circuit/Open

Some transmission controllers power groups of solenoids through several internal high-side outputs; supply C is the third of these rails, after A (P0657) and B (P2669). P2684 reports an open load on it. GM's 2023 and 2024 TCM tables tie the code to high-side output 7 and test it while the module powers down: with the output off and a low-side driver on, the load should drag the line low, so a level above 40 % of battery voltage is remembered as an open load and reported after the next start, Type A. Ford's 2024 summary assigns P2684 to high side driver 7 of the TR9070 dual-clutch gearbox, and Ford's 2014 Boss 302S code list carries it as well. Whatever hangs on that rail stops working, so a default gear or limp mode is likely.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 84

Possible causes

  • Broken wire or loose terminal between the module output and the supplied solenoids high
  • Corroded or unseated transmission connector or internal lead frame medium
  • High-side output inside the controller defective low

Symptoms

  • Transmission in default gear or limp mode
  • MIL on after restart
  • Several solenoid circuit codes stored together

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2684

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication