P2683
Engine Coolant Bypass Valve A Control Circuit High
For P2683 the drive of bypass valve A is shorted toward supply voltage or draws too much current. GM's 2016 Volt table has the VICM evaluate a short-to-high report from motor driver 1 while the valve is stopped or commanded to the high position; 16 failures out of 20 samples at 100 ms give a Type B fault. Volkswagen's 2014 Touareg Hybrid with the CGFA engine judges current instead and trips above roughly 2.2 to 4 A, which points to a jammed or shorted valve motor as well as wiring. Ford's 2019 hybrid summary uses a driver fault lasting over 5 s, and Ford's 2014 gasoline list shows P2683 with MIL. Coolant routing is then stuck, so heater output, warm-up or cooling of the affected circuit may change.
Possible causes
- Jammed valve or shorted valve motor drawing excess current high
- Drive wire shorted to battery voltage medium
- Faulty motor driver in the control module low
Symptoms
- Check engine light on
- Changed heater output or warm-up time
- Temperature warning in severe cases
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2683
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.