P2682
Engine Coolant Bypass Valve A Control Circuit Low
P2682 narrows the drive fault of bypass valve A to the low side: the output is pulled toward ground when it should not be. In GM's 2016 table for the second-generation Volt, the VICM sets it when motor driver 1 reports a short to low while the valve is commanded to the low position, with 4 failures in 5 samples and Type B. Ford's 2019 hybrid summary flags P2682 after a driver fault longer than 5 s, and it must be present before the stuck-open test P26AB can finish. Volkswagen's 2014 Touareg Hybrid (CGFA) uses a signal voltage below about 2.8 to 3.2 V. Ford's 2014 gasoline list marks it as a MIL code. The valve stays where it was, so warm-up or heat distribution may suffer.
Possible causes
- Drive wire to the valve motor shorted to ground high
- Internal short in the valve motor or electronics medium
- Coolant or water corrosion in the valve plug low
Symptoms
- Check engine light on
- Weak cabin heat or slow warm-up
- Possible overheating warning under load
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2682
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.