OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2680

Coolant Degassing Valve Control Circuit High

P2680 is the high-voltage fault of the degassing valve drive: the controller cannot pull the line down, so the valve stays in its unpowered state whatever is commanded. A wire touching a battery feed, an internally open solenoid, or a defective output transistor are the classic reasons. Because degassing only works when bubbles can reach the expansion tank, where the coolant calms and releases trapped gas, a valve stuck in the wrong state may leave air in the engine circuit or slow warm-up, depending on its default. No manufacturer documents P2680 publicly, and no threshold is published. The monitoring duty comes from CARB's comprehensive component rules. Check the coolant level and look for overheating signs.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 80

Possible causes

  • Control wire shorted to a battery feed high
  • Internally open solenoid of the degassing valve medium
  • Defective output stage in the control module low

Symptoms

  • Check engine light or stored code
  • Air pockets, gurgling or weak cabin heat
  • Temperature gauge higher than usual

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2680

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication