OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P267F

Control Module Internal Temperature Sensor A Circuit Intermittent/Erratic

Many control modules carry a temperature sensor on their own circuit board to protect output stages and, in transmission units, to back up fluid temperature. P267F adds an intermittent or erratic variant to the established family P0666 to P0669: the reading flickers, jumps or drops out briefly instead of being permanently too low, too high or implausible. Mercedes-Benz lists P267F00 as a temperature sensor fault of the control unit among the codes covered by its Intelligent Predictive Repair diagnosis for the 724.1 dual-clutch gearbox (bulletin LI27.00-P-077141, 2025), next to P0666 to P0669 and P0634. No thresholds are published. Since the sensor sits inside the module, repair usually means replacing or reprogramming that module.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 7F

Possible causes

  • Internal defect of the control module or its temperature sensor high
  • Unstable module supply or ground causing erratic readings medium
  • Module software misinterpreting the sensor signal low

Symptoms

  • Check engine or transmission warning light
  • Harsh or delayed shifts if the module uses substitute values
  • Often no noticeable symptom

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P267F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication