OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P267E

"B" Rocker Arm Actuator Position Sensor Circuit Intermittent/Erratic (Bank 2)

Here the bank 2 angle signal of lift actuator B is mostly plausible, yet it drops out for moments or jumps by amounts the motor-driven shaft could not cover in the time between two readings. The engine controller counts such events and sets P267E once they exceed its tolerance. Loose terminals, a wire cracked inside its insulation near the cylinder head, and interference from ignition or actuator wiring are the usual suspects; the fault often depends on heat or vibration. No manufacturer documents P267E publicly. CARB asks lift system inputs to be checked for signal quality, not only for fixed limits. While the reading jumps, lift control on bank 2 can hunt or be parked. Recording the signal while moving the harness helps locate the fault.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 7E

Possible causes

  • Loose or fretted terminal in the sensor connector high
  • Wire broken inside insulation, opening under heat or vibration medium
  • Interference from nearby ignition or actuator wiring low

Symptoms

  • Check engine light that may come and go
  • Brief hesitation or surging
  • Uneven running when lift control on bank 2 hunts

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P267E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication