OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P267D

"B" Rocker Arm Actuator Position Sensor Circuit High (Bank 2)

P267D is stored when the angle feedback of lift actuator B on bank 2 rises above its upper valid limit. Typical causes are an open sensor ground, which lets the signal float toward the reference, a signal conductor touching a supply line, or water bridging contacts in the connector. Systems such as BMW's Valvetronic, where an electric motor swings an eccentric shaft through a fixed arc, never place the sensor at the supply rail in normal operation, so such a value is rejected. No manufacturer documents P267D publicly; detection follows from CARB's input checks for variable lift. The controller holds bank 2 at a safe setting. Measure ground continuity first. Low-side partner: P267C; dropouts: P267E.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 7D

Possible causes

  • Open or high-resistance ground of the position sensor high
  • Signal wire shorted to reference or battery voltage medium
  • Moisture or corrosion bridging pins in the sensor plug medium
  • Defective position sensor B, bank 2 low

Symptoms

  • Check engine light on
  • Reduced power with lift fixed on bank 2
  • Slightly higher fuel consumption

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P267D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication