OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P267C

"B" Rocker Arm Actuator Position Sensor Circuit Low (Bank 2)

With P267C the engine controller reads the bank 2 position signal of lift actuator B below its lowest valid value. A sensor of this kind is designed so that even the end stop of the shaft keeps a margin to zero volts, so a reading near ground points to an electrical cause: the signal line shorted to chassis, a lost 5 V reference, or a sensor with an internal short. No manufacturer documents P267C publicly, and no thresholds are published. CARB treats out-of-range low inputs of variable lift systems as faults that must be detected. On a V engine the controller then usually stops adjusting lift on bank 2 only. Check the reference voltage at the sensor plug before replacing parts. P267D is the high-side counterpart.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 7C

Possible causes

  • Signal wire shorted to ground through damaged insulation high
  • 5 V reference supply to the sensor missing medium
  • Internal short in position sensor B, bank 2 medium

Symptoms

  • Check engine light on
  • Lift on bank 2 fixed at a default position
  • Noticeably weaker acceleration

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P267C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication