OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P267B

"B" Rocker Arm Actuator Position Sensor Circuit Range/Performance (Bank 2)

P267B concerns the bank 2 feedback of lift actuator B when the signal is electrically sound but the angle it reports does not follow the commanded value, moves too slowly, or contradicts the mechanism's known travel. Faulty learning of the end stops, a slipping sensor mount, wear in the shaft drive or a sticking actuator can all produce this picture. No manufacturer documents P267B publicly. The closest published case is Toyota's bank 1 counterpart P265B on Valvematic engines: bulletin T-SB-0098-19 starts with a learn value reset and an active test of the shaft angle, then replaces the lift controller if the fault returns. CARB expects variable lift monitors to detect missed targets and slow response. Lift on bank 2 is usually frozen.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 7B

Possible causes

  • End-stop learn values lost or wrong after repair or battery disconnect medium
  • Worn or sticking shaft drive of actuator B on bank 2 medium
  • Position sensor drifting or loose in its mount medium
  • Lift control software needing an update low

Symptoms

  • Check engine light on
  • Hesitation or reduced power
  • Uneven idle when lift is frozen on one bank

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P267B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication