OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P267A

"B" Rocker Arm Actuator Position Sensor Circuit (Bank 2)

Continuously variable lift systems turn a control or eccentric shaft with an electric motor and report the shaft angle back to the engine controller. On V engines each cylinder bank has its own mechanism; Nissan's VVEL on the VQ37VHR V6 and VK50VE V8 is an example of such a two-bank layout. P267A is the unspecific circuit fault of feedback sensor B on bank 2: the signal is unusable, but the controller does not classify it as too low or too high. No manufacturer documents P267A publicly; Toyota's bulletins use the B sensor letter only for its inline Valvematic engines and code P265B. CARB requires electrical checks on every input of a lift system. Expect connector, supply or ground problems first; P267B to P267E name more specific failure patterns.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 7A

Possible causes

  • Loose, corroded or damaged plug at the bank 2 position sensor high
  • Broken or chafed signal, reference or ground wire medium
  • Internal fault of position sensor B, bank 2 medium
  • Fault in the engine or lift control module input low

Symptoms

  • Check engine light on
  • Variable lift on bank 2 held at a fixed default
  • Reduced power or rough idle

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P267A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication