P2678
Coolant Degassing Valve Control Circuit/Open
In a sealed cooling system, air and vapour bubbles are carried through a thin vent line into the expansion tank, where they separate from the liquid; a bubble-free circuit avoids local hot spots, as cooling suppliers such as MAHLE point out. Some engines put an electrically switched valve in this degassing path so the controller can close it, for example to speed up warm-up. P2678 reports an open or unspecified fault in the drive circuit of that valve. No manufacturer documents P2678 or its valve publicly, so neither the purpose nor any threshold can be named. CARB requires electrical checks of controlled cooling system components. If the valve fails in the wrong state, warm-up can lengthen or venting may be impaired.
Possible causes
- Unplugged connector or broken wire to the degassing valve high
- Open solenoid coil in the degassing valve medium
- Faulty driver in the control module low
Symptoms
- Check engine light or stored code
- Longer warm-up or slow heater output
- Gurgling or air in the cooling system
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2678
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.