P2677
Air Cleaner Inlet Control Circuit High
The counterpart to P2676: the controller sees the drive line of the air cleaner inlet flap at too high a voltage, so it cannot pull the actuator in when asked. A short from the control wire to battery voltage, a failed output stage, or an open coil that leaves the line at supply level produce this pattern. In Ford's 2014 gasoline code list P2677 appears next to P2676, again as a continuous check without the MIL mark, meaning a stored code need not light the warning lamp. Beyond that list no manufacturer documents P2677 publicly. CARB's rules for monitored outputs explain why the driver stage is watched at all. The flap typically remains in its unpowered default position, and the car drives normally.
Possible causes
- Control wire shorted to battery voltage high
- Open coil in the flap actuator medium
- Failed output stage in the control module low
Symptoms
- Code stored, often without warning lamp
- Inlet flap remains in its default position
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P2677
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.