OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2674

Injection Pump Fuel Calibration Not Learned

Electronically governed diesel injection pumps meter the quantity per stroke themselves, and each unit differs slightly in how much it delivers for a given command. P2674 reports that the quantity correction for the installed pump has not been learned or stored in the controller. No manufacturer documents this code publicly; P2672 and P2673 cover the timing side of the same pump. CARB requires 2015-on vehicles whose fuel pumps or injectors carry production tolerance compensation, such as coded parts or trim resistors, to verify that the right compensation is in use. Without it, fuelling can drift, giving smoke, uneven idle or a shortfall of power until the learn routine is run.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 74

Possible causes

  • Quantity learn not run after pump or controller replacement high
  • Pump calibration data missing, wrong or not matching the installed pump medium
  • Fuel metering actuator fault preventing the learn from completing low

Symptoms

  • Check engine light on
  • Smoke or uneven idle
  • Reduced power

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2674

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication