P2670
Actuator Supply Voltage B Circuit Low
P2670 is set when the second high-side actuator supply delivers too little voltage while it is switched on, which nearly always means a short to ground somewhere on the supply line or in a load connected to it. GM documents it in several controllers. In the 16OBDG08 TCM tables for Silverado and Sierra a ground short is recognised at an impedance of 0.43 ohm or less, confirmed after three events, Type A. GM's 2023 TCM compares the supply voltage with battery voltage and also watches the average current, 60 ms to fail, Type A. In GM's hybrid tables (Volt THPC in 16OBDG01, HPC1 in 19OBDG01) high side driver 2 reports the short within about 0.13 s, again Type A after one trip. Solenoids on that supply drop out, so the transmission enters a failsafe mode.
Possible causes
- Supply wire chafed and shorted to ground high
- Shorted solenoid on the supplied group pulling the line down medium
- Faulty high-side driver in the controller low
Symptoms
- Failsafe gear, no normal shifting
- MIL on immediately
- Further solenoid circuit codes stored alongside
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2670
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.