OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P266F

A/C Refrigerant Distribution Valve A Control Circuit Driver Current/Temperature Too High

Refrigerant distribution valve A is a solenoid that opens or closes one branch of the A/C circuit, for instance a rear evaporator or a battery chiller. Its driver stage in the control module protects itself: when the output current rises above its limit or the chip overheats, it switches off and reports P266F. That usually means the load draws too much, through a shorted coil, a short in the harness or a valve that is mechanically stuck. No manufacturer documents P266F publicly; Ford lists only the open-circuit code P2611 for the same valve, and suppliers such as Egelhof build these shut-off valves as simple on/off solenoids. Unlike P2611 to P2613, which flag open and shorted wiring, P266F concerns the protection of the driver itself. The affected branch then stays closed.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 6F

Possible causes

  • Valve coil with shorted turns drawing excessive current high
  • Short in the valve harness or connector medium
  • Valve mechanically stuck so the coil stays loaded low
  • Overheated or defective driver stage in the control module low

Symptoms

  • One A/C zone or the battery cooling stays inactive
  • Fault may return after cooling down

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P266F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication