P266A
"A" Rocker Arm Actuator Position Sensor Circuit (Bank 2)
P266A is the basic circuit fault for the bank 2 position sensor of rocker arm actuator A. It only applies to engines that have a lift actuator with position feedback on each cylinder bank, which is rare; most switching rocker systems on V engines rely on oil pressure switches or none at all. No manufacturer documents P266A publicly, and even Toyota's Valvematic, which does use such feedback, is an inline design whose bulletins list a B code for its sensor. CARB still requires every electrical component of a lift system to be checked. If the controller loses this signal, it typically stops varying lift on bank 2, so power and refinement suffer.
Possible causes
- Poor contact at the bank 2 sensor connector high
- Damaged wiring between sensor and engine controller medium
- Failed bank 2 position sensor medium
Symptoms
- MIL on
- Lift on bank 2 no longer adjusted
- Reduced power and smoothness
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P266A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.