P2666
Fuel Shutoff Valve B Control Circuit Low
P2666 is stored when the control line of fuel shut-off valve B sits at too low a voltage, the typical sign of a short to ground between module and valve or inside the coil. Depending on how the driver is built, the valve may then open whenever the ignition is on, or the module switches the output off for protection. No manufacturer documents P2666 publicly. In bi-fuel vehicles such as GM's CNG Impala, the ECM controls normally closed cut-off valves on the gas side and changes over to gasoline as soon as it detects a problem in one fuel system; GM's Silverado and Sierra CNG models signal such errors with a rapidly flashing fuel indicator. P2665 is the open circuit and P2667 the short to voltage on the same valve, P0006 the low fault of valve A.
Possible causes
- Control wire chafed through and shorted to ground high
- Valve coil shorted internally medium
- Water ingress in the valve connector low
Symptoms
- Gas mode switched off, engine runs on gasoline
- Fuel mode lamp flashes rapidly
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2666
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.