P2664
"B" Rocker Arm Actuator Control Circuit High (Bank 2)
P2664 signals excessive voltage on the control line of solenoid B, bank 2. Contact with a powered conductor, for example where several solenoid and injector feeds share a connector, or a driver that can no longer pull the line down, are the typical causes. Depending on how the output is wired, the valve may then be energised all the time, keeping stage B on that bank engaged, or not work at all. No manufacturer publishes P2664 or a threshold for it. GM monitors the corresponding A circuits on its 2015 four-cylinders with a Type A driver test above 11 V, which shows the usual approach. CARB lists shorts to power among circuit faults that lift system outputs must detect. Compare P2663 for a low reading, P2660 for an open and P2654 on bank 1.
Possible causes
- Short to a powered feed inside a shared engine connector high
- Output driver in the control module stuck off medium
- Internally shorted solenoid B on bank 2 low
Symptoms
- MIL on
- Misfire or rough idle on bank 2 if the stage stays engaged
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2664
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.