OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2663

"B" Rocker Arm Actuator Control Circuit Low (Bank 2)

P2663 is stored when the control line to solenoid B on bank 2 reads too low, most often a short to ground somewhere between the module and the second cylinder head. On V engines that harness branch often runs along the back of the block or under the intake manifold, where heat and vibration wear through insulation. A coil whose resistance has collapsed gives the same picture. No carmaker documents P2663 publicly with thresholds. The principle can be seen in GM's 15OBDG05 table for 2015 four-cylinders on the matching actuator A circuit, with 100 failures in 120 samples above 11 V triggering a Type A fault. CARB counts circuit shorts among the faults to be caught. Many drivers switch off for protection, leaving stage B on that bank idle. Bank 1 equivalent: P2653.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 63

Possible causes

  • Bank 2 control wire worn through and touching ground high
  • Bank 2 solenoid B coil with collapsed resistance medium
  • Faulty output driver for bank 2 solenoid B low

Symptoms

  • MIL on
  • Stage B on bank 2 out of action, power or economy reduced

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2663

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication