P2661
"B" Rocker Arm Actuator System Performance/Stuck Off (Bank 2)
P2661 is the functional check of rocker arm stage B on bank 2: although the solenoid circuit is electrically sound, the commanded switch did not happen or the confirmation (an oil pressure switch reading or a change in cam phaser or engine response) stayed too small. Bank 2 means the engine has two cylinder heads, so the fault concerns only half of the cylinders, which may show as a difference between the banks. No manufacturer documents P2661 publicly with test conditions; CARB requires valve lift systems to detect hydraulic and mechanical faults that keep them from reaching the target. Oil starvation in that head, a partly blocked oil gallery, a sticking spool or seized pins are likely. Bank 1 counterpart: P2651; electrical fault: P2660.
Possible causes
- Low oil level or poor oil supply to the bank 2 head high
- Partly blocked oil gallery or screen on bank 2 medium
- Sticking solenoid spool or seized locking pins on bank 2 medium
Symptoms
- MIL after a completed drive cycle
- Less power in the range where stage B should engage
- Higher fuel consumption
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2661
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.