P265E
"B" Rocker Arm Actuator Position Sensor Circuit Intermittent/Erratic (Bank 1)
Here the bank 1 position signal for actuator B is neither stuck low nor high; instead it jumps, flickers or briefly vanishes faster than the mechanism could physically move. The engine controller compares successive readings and flags P265E when the rate of change or the number of dropouts exceeds what a motor-driven lift mechanism can produce. Typical culprits are fretting corrosion on the terminals, a conductor broken inside its insulation that only opens under vibration, or electrical noise from nearby ignition wiring. CARB asks for such signal quality checks on valve lift inputs. No manufacturer documents P265E publicly. The fault may come and go with temperature and road surface; the lift controller can hunt or fall back to a fixed setting.
Possible causes
- Fretting corrosion on sensor B terminals high
- Conductor broken inside its insulation, opening under vibration medium
- Interference from ignition or other high-current wiring low
Symptoms
- MIL on and off over several trips
- Surging or uneven power delivery
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P265E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.