P265D
"B" Rocker Arm Actuator Position Sensor Circuit High (Bank 1)
P265D stands for a feedback signal from position sensor B, bank 1, that sits above its valid ceiling. A reading pinned near the supply voltage usually means the signal is no longer pulled toward a real value: the sensor ground has opened, the signal wire touches a reference or battery line, or moisture has bridged pins in the plug. Because such a value would describe a position the actuator cannot reach, the controller discards it and holds lift at a default. CARB requires out-of-range high detection for every input of a variable lift system. No manufacturer publishes P265D; Toyota's public Valvematic bulletins mention only P265B for this sensor. Check ground continuity first, then the connector. Low side: P265C; intermittent faults: P265E.
Possible causes
- Open ground wire of position sensor B high
- Signal wire shorted to the 5 V reference or battery voltage medium
- Moisture bridging pins in the sensor plug low
Symptoms
- MIL on
- Lift frozen at default, weaker acceleration
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P265D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.