OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P265C

"B" Rocker Arm Actuator Position Sensor Circuit Low (Bank 1)

The angle or position sensor of rocker arm actuator B, bank 1, normally works inside a voltage band that never touches the lower rail. If the reading falls below that band, the engine controller logs P265C, because a value near zero cannot correspond to any real actuator position. Possible reasons are a signal conductor grounded through damaged insulation, a supply feed that has dropped out, or an internal sensor defect. CARB treats out-of-range low signals of valve lift inputs as circuit faults to be detected. No carmaker documents P265C publicly; Toyota's published Valvematic cases concern the B sensor's range code P265B only. Without trustworthy feedback the controller generally parks the lift in a safe position. High side: P265D; range fault: P265B.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 5C

Possible causes

  • Sensor B signal wire grounded through damaged insulation high
  • Sensor supply voltage missing medium
  • Internal fault in position sensor B medium

Symptoms

  • MIL on
  • Engine runs with fixed lift, less power

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P265C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication