OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P265B

"B" Rocker Arm Actuator Position Sensor Circuit Range/Performance (Bank 1)

Toyota documents this code on Valvematic engines, where an electric lift controller turns a shaft that alters rocker geometry and reports its angle back. P265B is set when that feedback stays electrically valid but does not track the target. Bulletin T-SB-0011-14 (2014 Corolla, 2ZR-FAE) pairs it with P2646 and fixes it by reflashing the ECM. T-SB-0098-19 (2018–19 C-HR with 3ZR-FAE, 2020 Corolla with 2ZR-FAE) adds the Valvematic angle codes P10A0 and P1055 and replaces the lift controller if the code returns. Both start with a learn value reset and an engine-off active test in which the actual angle should drop to about 105–106° and climb above 108°. CARB demands that such systems recognise deviations from the target and sluggish reaction.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number6 / 5B

Possible causes

  • Outdated ECM calibration (Toyota 2014 Corolla) high
  • Continuously variable lift controller sticking or worn medium
  • Stored learn values no longer match the mechanism medium
  • Drifting angle sensor in the controller low

Symptoms

  • MIL on, often together with P2646
  • Reduced power and slower throttle response
  • Fault may return after a short rev to 3,500 rpm

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P265B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication