P265A
"B" Rocker Arm Actuator Position Sensor Circuit (Bank 1)
Lift systems that move the rocker geometry with an electric motor, such as Toyota Valvematic, need a sensor that tells the engine controller the actual adjustment angle. P265A flags a general electrical problem with the feedback sensor that reports where actuator B on bank 1 sits: the controller sees no usable signal but cannot classify it as simply too low or too high. Toyota's own bulletins place a Valvematic feedback complaint under the neighbouring B sensor code P265B, which shows Toyota uses this sensor letter; P265A itself is not documented publicly by any manufacturer. CARB requires circuit checks on all inputs of a valve lift system. A loose connector, a broken reference or ground wire, or a sensor failure are the likely reasons; P265B to P265E narrow the fault down.
Possible causes
- Loose or corroded connector at the B position sensor high
- Open 5 V reference or sensor ground wire medium
- Failed position sensor inside the lift controller medium
Symptoms
- MIL on
- Lift held at a fixed value, sluggish response
- Higher fuel consumption
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P265A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.