P2659
"A" Rocker Arm Actuator Control Circuit High (Bank 2)
P2659 covers the bank 2 control circuit of actuator A reading high: the wire is shorted to a voltage source or the controller's driver stage no longer switches it to ground. No manufacturer documents P2659 publicly. On bank 1, GM's 2015 table 15OBDG05 checks this as P2649 only while the driver is commanded on, again with 100 failures out of 120 samples and a Type A fault. A short of this kind may keep the solenoid powered, so the rocker arms of bank 2 could stay switched; alternatively the controller cuts the output. Compare with P2658 for the low side and P2655 for an open circuit; measuring the voltage at the unplugged connector separates harness from controller faults.
Possible causes
- Bank 2 control wire shorted to a voltage source high
- Controller output stage no longer switching to ground medium
- Neighbouring pins bridged in the connector low
Symptoms
- MIL on immediately
- Bank 2 lift stays switched or switching is disabled
- Rough idle in some cases
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2659
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.