P2658
"A" Rocker Arm Actuator Control Circuit Low (Bank 2)
P2658 flags the bank 2 control line of rocker arm actuator A as too low, the classic sign of a short to ground or a coil with damaged windings. The test is purely electrical and runs whenever the controller drives the output, regardless of oil condition. No manufacturer documents P2658 publicly; GM's equivalent for bank 1 (P2648 in 15OBDG05) needs more than 11 V and 100 failures out of 120 samples, Type A. Inspect the bank 2 solenoid connector, harness clips near the exhaust manifold and the coil resistance. If only one bank can switch, the controller may disable the feature altogether, leaving reduced power or economy.
Possible causes
- Bank 2 control wire shorted to ground high
- Damaged winding in the bank 2 solenoid medium
- Harness insulation damaged by exhaust heat low
Symptoms
- MIL on immediately
- Lift switching disabled
- Less power or higher consumption
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2658
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.