P2657
"A" Rocker Arm Actuator System Stuck On (Bank 2)
P2657 is the stuck-on case for bank 2: actuator A keeps the rocker arms of the second bank in their switched mode after the controller has asked for the base setting. On a cylinder deactivation design that could mean valves stay closed on that side; on a two-step design the high-lift profile stays active at idle. No manufacturer documents P2657 publicly; GM's bank 1 test P2647 (2015, 15OBDG05) shows the principle, flagging a pressure ripple below its limit during a deliberate toggle. A solenoid that leaks oil when off, a jammed locking pin or debris in the oil passage of that bank are candidates. Misfires on one bank and a lumpy idle are typical.
Possible causes
- Bank 2 solenoid passing oil while switched off high
- Locking pin stuck in the engaged position medium
- Debris in the bank 2 oil passage low
Symptoms
- Misfire codes on bank 2 cylinders
- Lumpy idle
- Poor low-speed driveability
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2657
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.