P2656
"A" Rocker Arm Actuator System Performance/Stuck Off (Bank 2)
For bank 2, P2656 reports that actuator A was told to switch the rocker arms but the expected change in valve lift did not show up, or it was too small. Since such engines give every bank a separate oil feed and solenoid, a clogged screen or sticking spool on that side alone is enough. No manufacturer publishes P2656; GM's bank 1 test (P2646 in 15OBDG05) shows the usual method: an intrusive lift toggle at moderate load and warm oil, judged by oil-pressure ripple. CARB permits two-step systems to flag faults only once emissions exceed the threshold, but every such failure must then be caught. Low oil level, wrong viscosity and sludge deserve the first look.
Possible causes
- Low, wrong or sludged engine oil high
- Clogged oil screen or sticking spool at the bank 2 solenoid medium
- Seized locking pin in a bank 2 rocker arm low
Symptoms
- MIL on after a completed test
- Weaker response at higher engine speed
- Higher fuel consumption
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2656
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.