P2655
"A" Rocker Arm Actuator Control Circuit/Open (Bank 2)
P2655 is the bank 2 twin of P2645: on a V or boxer engine with a separate rocker arm actuator per cylinder bank, the drive circuit of actuator A on the side without cylinder 1 is open, so the state the controller sets and the state it sees on the wire differ. No manufacturer documents P2655 publicly. As an analogy, GM's 2015 table 15OBDG05 runs the bank 1 version with 100 failures out of 120 samples at 250 ms intervals and a Type A MIL. A broken wire in the harness running across the engine, a backed-out terminal or an open coil are plausible. Only bank 2 then loses lift switching, which can make the banks run unevenly and cause rough running.
Possible causes
- Broken wire in the harness to the bank 2 solenoid medium
- Terminal pushed out of the connector housing medium
- Open coil in the bank 2 oil control solenoid medium
Symptoms
- MIL on
- Banks run unevenly, slight roughness
- Reduced power or economy
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2655
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.